87240系列DC/DC位移傳感器

對于位移和所有機械值，可以轉換為位移，集成放大器，無滯后，大溫度范圍

Features
- 量程范圍從0 … ±1.27 mm 到 0 ... ±76.20 mm
- 集成放大器
- 沒有滯后現象
- 大溫度范圍從-50°C......+120°C
- 適用于3 bar的液壓油
- 保護等級IP64

Product data

型號	87240
量程范圍	0 … ± 1.27 mm 0 … ± 1.8 mm 0 … ± 2.54 mm 0 … ± 3.8 mm 0 … ± 6.35 mm 0 … ± 9.5 mm 0 … ± 12.70 mm 0 … ± 19.0 mm 0 … ± 25.40 mm 0 … ± 38.1 mm 0 … ± 50.80 mm 0 … ± 69.5 mm 0 … ± 76.20 mm 0 … ± 82.5 mm
信號輸出類型
保護等級
工作溫度
激勵供電電壓
復位彈簧
具體特征

Description

Displacement and all mechanical values which can be converted to displacements (e.g. compressive and tensile force, strain, torque and vibration) may be measured by this DC/DC displacement sensor. Typical application areas are the measurement of displacement and strain on machines, servo systems, vehicles, on test plants, in civil engineering and tunnel construction.

An integrated maintenance-free electronic and a high-level DC output signal provide an easy handling without any problems.

Displacement sensors of series 87240 convert a displacement into an analog electrical signal. They consist of a differential transformer with moveable core, an oscillator and a demodulator. These components are integrated and encapsulated in a cylindrical housing made of stainless steel. The sensors are energized by DC voltage, which is converted to AC by the oscillator and brought to the primary coil of differential transformer. The voltages induced by the two secondary windings of the transformer are demodulated, filtered and switched inverse to each other. The result is a 0 V signal, if the core is in the center position.

The direction of an axial core displacement is shown by the polarity of the output voltage. The amplitude of the voltage changes proportional to the magnitude of the core’s displacement and respectively to the measured deflection.

In and output terminals of the displacement sensor are galvanically insulated and there is no connection to the housing of the sensor.

The mounting of the DC/DC displacement sensor will be done e.g. by a clip enclosing the sensor’s housing. The dynamic unit to be measured should be connected to the core of the sensor. To avoid an influence to the magnetic field and the measured value, coupling elements have to consist of a non magnetizable material like brass, aluminium or non-magnetizable steel.
Downloads

Data sheet

8739參數資料
EN