江蘇春晨電纜有限公司專業生產EV-EFPF充電系統電纜，乙丙橡膠絕緣銅絲編織屏蔽氯丁橡膠（或類似材料）護套電動汽車傳導充電系統用電纜，
在電線電纜的生產中，由于其原材料成本占生產成本的80%以上，而銅、鋁、鋼芯、橡膠、塑料和護套等材料又為原材料成本的主體，這就要求電線電纜企業在如何設計有特色的產品、節約原材料、開發新型環保材料等方面下功夫。因此，今后必須考慮以下措施，來打造電線電纜行業的循環經濟：EV-EFPF充電系統電纜
In wire and cable production, because of the cost of raw materials accounted for more than 80% of production costs, while copper, aluminum, steel, rubber, plastic and core sheath material as the main raw material costs, which requires the wire and cable enterprises in how to design unique products, saving raw materials, development of new environmentally friendly materials so hard. Therefore, the following measures must be taken in the future to create a recycling economy in the wire and cable industry:
首先，淘汰冷軋機和黑銅桿。用冷軋機軋制出芰8黑銅桿的生產工藝是落后的，而且其黑銅桿氧化物含量高，導電率低，性能差，拉力重量比小，耗材、耗能、污染嚴重，應該淘汰。
First, the cold rolling mill and the black copper rod. With the rolling mill production process, 8 black copper rod is backward, and the black copper oxide content of high conductivity, low tension, poor performance, weight ratio of small, material and energy consumption and serious pollution should be eliminated.
其次，積極推廣鋁稀土優化處理技術。 用連鑄連軋工藝生產電工鋁桿在國內已相當普及，性能也良好，但設備仍停留在70年代初期開發水平，技術上沒有多大創新。要積極推廣我國*的鋁稀土優化處理技術。并利用引進的部分關鍵設備和技術添加鋁鋯合金，將熔鋁燃煤爐改造成熔鋁燃油或天然氣爐，全部消除熔鋁燃煤爐燃煤煙塵和煙氣的排放，并設置煙氣過濾裝置凈化煙氣，提高排放質量，提高成品率，降低成本，同時使導線工作溫度從70℃提高到150℃，載流量提高1.6倍。
Second, actively promote the optimization of rare earth aluminum processing technology. Continuous casting and rolling process for the production of electrical aluminum rod in the country has been quite popular, the performance is also good, but the equipment is still in the early 70s, the development of the level of technology is not much innovation. To actively promote China's unique aluminum rare earth optimization technology. The introduction of the key part and the use of special equipment and technology of aluminum zirconium alloy, the aluminum melting stove into molten aluminum fuel oil or natural gas furnace, the total elimination of aluminum melting stove coal smoke and flue gas emissions, and set the flue gas purification device of flue gas emissions, improve quality, improve the yield and reduce the cost at the same time. The wire temperature is increased from 70 to 150 DEG C., carrying capacity is increased by 1.6 times.
第三，積極引進技術，自主創新開發性能優良的電線電纜設備。目前，電線電纜主導產品的關鍵生產設備與*進設備比較，技術水平差距仍然很大，主要表現在生產率低、自動化程度不高、能耗較大、可靠性較差，還不能滿足行業發展的需要，消化吸收嚴重滯后。電線電纜設備的技術水平、性能和可靠性對于提高電線電纜產品質量、生產效率、材料利用率均有不可估量的好處。要積極引進技術，自主創新開發性能優良、高水平的電線電纜設備，為打造電線電纜行業的循環經濟服務。 zui后，積極開發環保型電線電纜產品，加強廢電線電纜產品的回收工作。 目前，生產電線電纜產品大量使用橡膠、聚氯乙烯、聚乙烯等高分子化工材料。在生產電線電纜產品過程中產生大量有毒有害氣體。因此要積極開發環保型電線電纜原材料，生產產品環保型電線電纜。日本藤倉等電纜公司在開發了環保型電線電纜產品后，為了壟斷市場，積極推進政府頒布環保型電線電纜產品標準。近年來，環保型電線電纜產品的銷售份額急劇擴大，普通的電線電纜和阻燃電線電纜根本無法與其競爭。 在電線電纜生產過程中產生的邊角余料，可以直接回收回用。建議成立專業的“聚氯乙烯”廢料回收處理廠，定點加工，改作他用，避免產生二次污染。
Third, the introduction of technology, independent innovation and development of excellent performance of wire and cable equipment. At present, wire and cable products led the key production equipment and advanced equipment, technical level is still a big gap, mainly in low productivity, low degree of automation, high energy consumption, poor reliability, can not meet the needs of the development of the industry, digestion and absorption lag. The technical level, performance and reliability of wire and cable special equipment can improve the quality, production efficiency and material utilization rate of wire and cable products. To actively introduce technology, independent innovation and development of excellent performance, high level of special equipment for wire and cable, wire and cable industry to create a recycling economy services. Finally, actively develop environmentally friendly wire and cable products, strengthen the recycling of waste wire and cable products. At present, the production of wire and cable products, rubber, polyvinyl chloride, polyethylene and other high polymer chemical materials. In the production of wire and cable products in the process of generating a large number of toxic and harmful gases. Therefore, it is necessary to actively develop environment-friendly wire and cable raw materials, production of environmentally friendly wire and cable. Japan's Fujikura cable companies in the development of the environmental protection type of wire and cable products, in order to monopolize the market, and actively promote the government environmental protection type of wire and cable products standards. In recent years, the sales share of environment-friendly wire and cable products has expanded rapidly, and the ordinary wire and cable and flame retardant wire and cable can not compete with them. In the production of wire and cable in the production process of the side of the residual material, can be directly recycled. Recommended the establishment of a professional "PVC" waste recycling plant, fixed-point processing, used for other purposes, to avoid pollution two.
