• <del id="qqie6"><sup id="qqie6"></sup></del>
  • <tfoot id="qqie6"></tfoot>
  • <ul id="qqie6"></ul>
  • 西安慶成機電設備有限公司
    免費會員

    J-SB2電振音叉實驗儀操作指南

    時間:2016/10/26閱讀:1285
    分享:

    電振音叉說明書J-SB2

    Users Manual for J-SB2 Fork Oscillator

    用途:

    Application:

    供大專學校基礎物理實驗,作邁爾德氏弦振動試驗之用。

    Specially used for Maier De's string vibration test in fundamental physics experiment of universities and colleges

    結構及基本性能:

    Structure and basic properties:

           本儀器為一大型音叉,由整塊的鋼材切削而成。在兩叉枝的頂端,裝置記錄筆尖一對,以供記錄波紋之用。叉柄固著于木質底板上的Ω型底坐上,在兩叉枝間距叉頂約三分之一處,裝置一電磁鐵,在左側叉枝的外側配備斷續接觸器,接通電流后,配合音叉的振動,形成勵磁線圈斷續通電,致使電磁鐵產生間斷吸力,驅使音叉作長期的振動。本音叉頻率約為100/秒,每具音叉的實際頻率數均用硬印標出。標出的頻率數據就是是音叉頂部裝有一對記錄筆尖的頻率,如將此等附件連同螺絲全部卸去,則頻率約增加4分之3周。由于音叉叉枝質量較大,故在實驗中如弦振動駐波試驗等,負荷稍有變動時,對頻率的影響不大。

    This instrument is a large tuning fork made from the cutting of one-piece steel material. A pair of recording pen-points is mounted at the top of two branches for the purpose of recording ripples. Fork handle is fixed on the Ω type seat of wooden bottom plate, one electromagnet is arranged between two fork branches and about one third away from the fork top, and an intermittent contactor is mounted at the outside of left-side fork branch. After the power supply is switched on, it is possible to form excitation coil, provide intermittent electricity, cause the electromagnet to produce intermittent suction, and drive the tuning form to produce long-term vibration. The frequency of tuning fork is 100 cycle per second, and the actual frequency number of each of tuning fork is marked with embossing seal. The marked frequency data equals to the frequency of a pair of recording pen points mounted at the top of tuning fork, and the frequency may increase 3/4 cycle, provided that these accessories and other screws are compley dismantled. Due to the larger mass of tuning form branch, slight changes in load may not have significant impact on frequency in such experiment as string vibration standing wave test.

    使用方法:

    Use Method:

           將本儀器底板上所附電源輸出叉頭接在底板的接線柱上(或根據需要另接電源),調節斷續器接觸點螺絲,使音叉維持穩定振動,叉端振幅約達1.5m/m。調節適度后,即將螺帽固緊使不至松動。一次調節后如所用電源的電壓不變,則以后使用時可不必再行調節。在使用時如音叉呈靜止狀態,則斷續器不能起正常的作用。故在接通電流時,可輕敲叉枝,協助音叉起動。

       Connect the power output plug (attached on the bottom plate of this instrument) onto the terminal of bottom plate (or otherwise connect to power as required), regulate the contact point screw of interrupter to enable the tuning fork to maintain steady vibration, and the fork-side amplitude may reach 1.5m/m. After an appropriate adjustment, it is necessary to tighten the screwed cap and avoid looseness. Readjustments are not required in the later uses, provided that the voltage of power supply remains unchanged after the first time of adjustment. The interrupter can not play a normal role if the tuning fork is in resting state during application. Therefore, it is possible to gently strike the fork branch to help the start of tuning fork when the current is switched.

           本音叉叉枝的頂端有螺絲,作邁爾德氏弦振動試驗時,可將弦線一端用螺絲固著。

        Screw is mounted at the top of tuning fork branch, and it is possible to fix one end of string with screw when Maier De's string vibration test is being conducted.

    儀器的保管:

    Storage of Instrument:

           音叉的叉枝上如發生銹蝕等變化或附著厚層油污,能直接影響音叉的頻率,故在使用之前,須以柔軟紗布將油污楷試潔凈,在使用完畢之后,須遍涂防銹油,音叉須放置于干燥處,以防銹蝕。

    The frequency of tuning fork may be directly affected if erosion and other changes exist in the fork branch of tuning fork, or the branch is covered with thick oil stain. For this regard, it is necessary to use soft gauze to wipe off the oil stain before the application of this instrument. Moreover, it is also necessary to coat anti-rust oil throughout the instrument after the completion of application. The tuning fork must be stored at dry place to avoid corrosion.

     

    重量:…………………………………………………………………………………….3.5公斤

    Weight: ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ..  About 3.5 kg

    外形尺寸:………………………………………………………………….音叉叉枝長約300毫米

    Dimension:                       Length of tuning fork branch is about 300mm

     

                                                               厚約       8毫米

                                                               Thickness    8 mm

                                                               寬約     23毫米

                                                               Width    23 mm

                                                               木底板  160x395毫米

                                                      Wooden bottom plate 160x395 mm

     

    會員登錄

    ×

    請輸入賬號

    請輸入密碼

    =

    請輸驗證碼

    收藏該商鋪

    X
    該信息已收藏!
    標簽:
    保存成功

    (空格分隔,最多3個,單個標簽最多10個字符)

    常用:

    提示

    X
    您的留言已提交成功!我們將在第一時間回復您~
    在線留言
    主站蜘蛛池模板: 国产成人无码一二三区视频| 在线成人播放毛片| 成人黄色免费网站| 成人小视频免费在线观看| 成人狠狠色综合| 国产成人精品97| 久久亚洲国产成人精品无码区| 成人网视频免费播放| 国产成人综合精品一区| 久久亚洲AV成人无码| 成人免费看黄20分钟| 亚洲av午夜成人片精品网站| 成人午夜在线视频| 亚洲AV成人片色在线观看高潮| 成人av免费电影| 欧美成人www在线观看网页| 国产成人一区二区三区视频免费| 一级毛片成人午夜| 国产成人免费高清在线观看| 欧美成人精品大片免费流量| 亚洲欧洲国产成人精品| 成人动漫视频在线| 欧美成人精品一区二区| 免费h成人黄漫画嘿咻破解版| 成人在线观看国产| 欧美videosex性欧美成人| 亚洲成人网在线观看| 小明天天看成人免费看| 日韩国产成人精品视频人| 18级成人毛片免费观看| 亚洲女成人图区| 国产成人av在线影院| 成人免费看黄20分钟| 成人做受120视频试看| 成人欧美精品大91在线| 欧美综合成人网| 成人综合激情另类小说| 欧洲成人全免费视频网站| 我的初次内射欧美成人影视| 欧美成人精品第一区| 成人爽a毛片在线视频|