| Screw tightening control |
| ● DIGITAL TORQUE DRIVER DID-4M |
 |
| (1) Unify the display sectiona frame. It became stronger. (2) Display Measurement Mode, Unit, Etc. on Display Section. (3) Data Output is USB Form. (4) Prepare each button in accordance with operation. Button operation became simple |
| ＊The torque screwdriver is Ergonomiclight weight, yet ruggedly constructed ＊Available in: lb-in, kg-cmN-m ＊Peak, Real TimePeak Down measuring mode (selectable) ＊800 data memory. ＊Programmable HighLow set points with both audible beepGreen/Red LED indicator for uniform torque tightening or GO/NO GO testing ＊Programmable screw tightening counter ＊Programmable Auto Zero function resets unit to zero for easy operation ＊Both CWCCW operation ＊ASCII format output(USB) ＊Runs on internal NiCad batteries (for 12 hours) Auto shut-off after 10 min. of non-use ＊ AC chargercarrying case included. |
| Specification | DID-4 | |
| Measuring range | 0.020 - 4 N-m | |
| 0.20～40 kgf-cm | ||
| 0.20～35 lbf-in | ||
| Accuracy | ± 0.5% (in case of reading 499 or less = last digit +/- 3 reading) | |
| Display | The 4 figures digital display of LCD | |
| The measurement direction | CW-CCW (rightleft) | |
| Measuring mode | P-P Peak | Holding Peak Load Value |
| T-R Track | Showing Real time torque value ( Used for Zero-Adjustment ) | |
| P-D Peak down | Holding Load Value at the moment to change from upward to downword | |
| C Real-time output | Load torque value is outputted every about 1/ 160. | |
| Decision function | Setting of torque value | Programmable HighLow setpoints with both audible beepGreen/Red LED indicator for uniform torque tightening or GO/NO GO testing |
| The Maximum, the minimum,the average value | Displays, memoryoutput the data number, the maximum, the minimum,the average value of the measured value to 30 data. It can save by a maximum of 10 channels. | |
| Data spec. | Data transfer | ASCII format (Baud rate : 19200) When outputting data,the cable(USB miniB) is needed. |
| Data memory | 800 data / ten channels data | |
| A setup of the number of counts | One to 99 count (count in a direction with a bundle) | |
| Power supply | Ni-Cd chargeable battery 1.2V×4cells 600mAh | |
| Auto power save | 10 minutes no use, automatically switch off. | |
| Charging time | From empty - less than 5hours | |
| Continunous working time | 12 hours | |
| Bit /Socket part | HEX6.35 | |
| Weight | about 400g | |
| Attachment | Bit （＋）?。＃薄。＃病?/td> | |
| Accessories (one piece each) | Dedicated AC/DC Adaptor (Charger),100～230VAC | |
| An inspection report, a proofreading certificate, a traceability system figure | ||
