恒溫溢流水箱設有循環裝置,采用高智能控溫儀.具有控溫精度高,整機設計 防劃痕,外觀大方。
The constant temperature overflow water tank is equipped with a circulation device and adopts a high intelligent temperature controller. It has high temperature control accuracy, the whole machine design anti-scratch, and elegant appearance.
恒溫溢流水箱技術參數.
★電源:220V±10％ 50HZ
★加熱功率1000W
★制冷功率：550W
★控溫精度,±0.1℃
★控溫范圍：10---60℃
★容積30升
★外形尺寸：800X590X670mm
★重量：25kg
Technical parameters of constant temperature overflow water tank.
★ Power: 220V ± 10% 50HZ
★ Heating power 1000W
★ Cooling power: 550W
★ Temperature control accuracy, ± 0.1 ℃
★ Temperature control range: 10 --- 60 ℃
★ Volume 30 liters
★ Dimensions: 800X590X670mm
★ Weight: 25kg
恒溫溢流水箱使用方法:
★ 使用是液體介質液面得低于臺面3cm.
★選用電源功率要大于或等于儀器的總功率,另電源必須有良好的接地裝置.
★儀器應放置于通風干燥處,周圍應與其他物體有300mm以上距離.
★使用完畢,關閉電源.按下電源插頭.
How to use the thermostatic overflow water tank:
★ The liquid level of the liquid medium should be 3cm below the countertop.
The power of the selected power supply must be greater than or equal to the total power of the instrument, and the power supply must have a good grounding device.
The instrument should be placed in a ventilated and dry place, and the surrounding should be more than 300mm away from other objects.
★ After use, turn off the power. Press the power plug.
儀表操作:
★開啟電源開關
★開啟循環開關
★按住.SET鍵0.5秒,儀表進入主控設定狀態,設置所需溫度,設定完畢再按SET鍵0.5秒返回儀表正常控制狀態
★長期使用儀器必須放掉儀器內的液體.
Constant temperature overflow water tank instrument operation:
★ Turn on the power switch
★ Turn on the cycle switch
★ Press and hold the .SET key for 0.5 seconds, the meter enters the main control setting state, set the required temperature, and press the SET key for 0.5 seconds after the setting is completed to return to the normal control state of the meter
The liquid in the instrument must be discharged for long-term use.
注意事項：
★設備安裝時,請檢查連接是否正確.
★為了確保安全,請接好地線
★如果設備工作正常,請和廠家或中間商聯系,要私自拆卸.
★冬季一定要把循環水泵內的水放凈防止動裂
Note for constant temperature overflow water tank
When the device is installed, please check whether the connection is correct.
★ To ensure safety, please connect the ground wire
If the equipment works normally, please contact the manufacturer or middleman and disassemble it by yourself.
★ In winter, the water in the circulating pump must be drained to prevent it from cracking.
