XL-8015 耐磨試驗機 UL規格試料磨平機
耐磨試驗機在將橡膠或塑膠啞鈴狀試片磨平、磨薄或磨出所需之厚度，以供拉力、老化、耐油等試驗之用。試片臺左右、上下及前后可移動，以扳手操作。
符合UL1581標準第420.6條規定。
Buffing machine （AUGUST 2, 2006 - UL 1581）
420.6 A power-driven buffing machine (grinding wheel) is appropriate for buffing irregularities from the ples from which die-cut specimens are to be prepared. The abrasive wheel is to be of about No. 36 grit (particle size of 0.019 inch or 0.486 mm). The wheel is to run true and is not to vibrate. The diameter of the wheel is not specified; however, 4-3/4 – 6-1/4 inch or 0.12 – 0.16 m has been found appropriate. The rotary velocity of the wheel is to be 2500 – 3500 r/min. The diameter and rotary velocity of the wheel are to be selected to give the wheel a peripheral speed (rpm×p×wheel diameter) of 3000 – 5000 ft/min or 15 – 25 m/s. CAUTION – The maximum wheel diameter stated in this paragraph and the maximum wheel rpm stated in this paragraph shall not be used together as this combination will result in a peripheral speed above 5000 ft/min or 25 m/s. This applies even for wheels that are marked as being intended for a peripheral speed above 5000 ft/min or 25 m/s. The machine is to have a slow feed that applies light pressure and removes very little material at one cut, thereby not overheating the specimen or the wheel.
主要技術參數
砂 輪：36 ? 5″
砂輪線速度：3000～5000feet/min或15～25m/s
皮帶輪加速比：2：1
體 積：50×60×40cm
重 量：50kg
電 源：1∮，AC220V 50Hz
注：以上價格有誤，僅供參考，來電更多優惠！
試料磨平機磨出一定厚度的片狀，通過沖片機和啞鈴刀制出啞鈴試片，用于老化試驗和拉伸試驗。
下圖為沖片機，沖切啞鈴試片專用。
