德國奧萊斯OLES進口高加系統閥
【進口高加系統閥】特點：
入口閥和止回閥配套使用,往高壓加熱器注水后，隨著水的壓力不斷升高，當壓力升至一定的壓力后，借助作用于入口閥閥桿截面的壓差使閥桿向上運動帶起閥瓣開通了進入高壓加熱器的通道，使水進入高壓加熱器，此時高壓加熱器投入運行
德國奧萊斯OLES進口高加系統閥
【進口高加系統閥】特點：
入口閥和止回閥配套使用,往高壓加熱器注水后，隨著水的壓力不斷升高，當壓力升至一定的壓力后，借助作用于入口閥閥桿截面的壓差使閥桿向上運動帶起閥瓣開通了進入高壓加熱器的通道，使水進入高壓加熱器，此時高壓加熱器投入運行。當高壓加熱器發生事故管系破裂，高壓加熱器內水位超過允許值時，水位信號通過電器裝置打開快速啟閉閥，凝結水進入入口閥上部活塞缸內，壓下活塞,推動閥瓣下移，關閉高壓加熱器的進口，打開旁路，高壓加熱器停止運行，整個動作時間為2秒鐘。
The inlet valve and check valve are used together. After water is injected into the high pressure heater, the pressure of water increases continuously. When the pressure rises to a certain pressure, the valve stem moves upward with the help of the pressure difference acting on the cross section of the inlet valve stem, and the valve disc opens the passage into the high pressure heater, so that the water enters the high pressure heater. At this time, the high pressure is added. The heater is put into operation. When the high-pressure heater pipe system breaks down and the water level in the high-pressure heater exceeds the allowable value, the water level signal opens the quick opening and closing valve through the electrical device, condensate water enters the piston cylinder of the upper part of the inlet valve, depresses the piston, pushes the valve disc down, closes the inlet of the high-pressure heater, opens the bypass, and the high-pressure heater stops running. The whole action time is 2 seconds.
產品技術參數：
主體材質：;1、WCB、ZG20CrMo、Cr5Mo、ZG20CrMoV 2、25#、12Cr1MoV 3、ASTM A216 WCB、ASTM A217 WC6、ASTM A217 WC9 4、ASTM A105、 ASTM A182 F11、ASTM A182 F22
使用溫度： 1、WCB：-29℃~425℃ 2、合金鋼：-29℃-540℃、-29℃-570℃
適用介質：水、蒸汽等
連接方式：焊接
傳動方式：手動、電動、液動
